Rohde & Schwarz PR200 Receiver Preliminary Mitigation Setup
Setup procedure for the PR200 when using Receiver mode. This is the preferred mode to be in when mitigation interference. Constructive feedback is appreciated. Happy hunting.
Public Safety Interference from Wireless Carriers
This cases study was co-authored back in 2010 with Agilent Technologies (now Keysight). GSM issues identified during our research is now amplified with the increase in RF power. This makes handset filtering so very important in order to prevent input saturation.
U.S. Border Mobile Power Measurements Using RSRP for FCC Field Agents & Wireless Carriers
U.S. and Mexico border U.S. power flux density and mobile RSRP pass/fail levels. Measurements should be performed on ALL pertinent carriers in the lower and upper 700 MHz bands. It is important ALL PRBs are brought to full power to demonstrate worse-case impact on interference.
Spectrum Analyzer Input Saturation & IM
This article was put together over 10 years ago to advise individuals mitigating interference that their spectrum analyzers can be in saturation without them knowing this is occurring. Most manufacturers have different methods for letting users know when their test unit is in saturation; however, this does not apply for lower power levels. It takes […]
Rohde & Schwarz PR100 PSCAN Mitigation Setup
Use this mode when frequency spans are greater than 10 MHz. Constructive feedback is always appreciated. Happy hunting.
Rohde & Schwarz PR100 FFM Mitigation Setup
Setup procedure for the PR100 when using FFM mode. This is the preferred mode to be in when mitigation interference. Constructive feedback is appreciated. Happy hunting.
3.5 GHz CBRS and 3.7 GHz C-Band Mitigation
This article briefly touches on U.S. 3.5 GHz Citizens Broadband Radio Service (CBRS) and 3.7 GHz C-Band, how CBRS users are managed to minimize spectrum conflicts, and options for mitigating interference. Test equipment configurations include spectrum analysis (SA) with and without time-gating, real-time spectrum analysis (RTSA) using time markers, and the use of external bandpass […]
Technical Advisor – Dr. James Potter
I am excited and honored to announce Dr. James Potter has joined Bryant Solutions, Inc. as a technical advisor. Jim and I first met back in 1986 when I was first interviewed and subsequently hired by AccSys Technology, Inc. in Pleasanton, California, where Jim was a co-founder and research scientist. I still remember asking him […]
Welcome
Welcome to our resources page for all topics related to ELF, RF, microwave, and millimeter wave. These topics will also typically be posted on our company LinkedIn page, so be sure to follow us on LinkedIn for the latest topics.